top of page

Installing the Pro Mounting Pin

1.jpg

What you will need:  1/2" wrench

2.jpg

Step 1: Remove the top nut and washer from the back.

3.jpg

Step 2: Remove the top screw

4.jpg

Step 3: Remove the main handle and thick washer

5.jpg

You will reuse all washers and nuts.

6.jpg

Step 4: Place thin washers on the screws of the Pro Mounting Pin...

8.jpg

...and mount it as shown:

9.jpg

Step 5: Replace the top nut and washer, and tighten the nut.

10.jpg

Step 7: Add the thick washer for the handle...

11.jpg

...and now add the handle.

12.jpg

Step 8:  Replace the thumb screw on the mounting stem and you're all set!

13.jpg

Note: the thumb screw is not needed if you're mounting on a Combo Stand or other Junior Socket.

bottom of page